ZFS Compression
ZFS supports transparent compression of data at the block level for datasets. Enabling compression can improve storage efficiency by decreasing the amount of data written to disk and improve read performance for large files, as less data needs to be read from disk. The tradeoff is that compression consumes additional CPU resources on the Lustre server that imports a zfs dataset with compression enabled.
Compression is typically most beneficial for OSTs since this is where most of the filesystem data is stored. Enabling compression for MDTs is safe, but there may not be as much benefit since most of the data on an MDT is file metadata which ZFS often compresses by default. If you are using Data on MDT (DoM), then there may be a benefit to using compression since some file data is stored on the MDT. The decision to enable or disable compression on OSTs will need to be evaluated by each site depending on their specific needs and performance requirements. Since compression can be enabled/disabled without affecting exising data, it is easy to test both scenarios without the risk of data loss.
Check ZFS compression
To check if compression is enabled for an OST, run:
zfs get compression <OST_dataset>
Example output will look something like this:
[root@oss1][~]# zfs get compression lustre-OST0000 NAME PROPERTY VALUE SOURCE lustre-OST0000 compression off local
Set ZFS compression
To enable compression, run:
zfs set compression=on <OST_dataset>
This turns on compression with the default algorithm (lz4 since ZFS version 0.6.5). Other compression algorithms are available, and a list of supported algorithms can be found by looking at the zfsprops man page. To use a different algorithm, replace the compression=on option with compression=<algorithm>. The lz4 algorithm is likely the best choice for now. It has been tested extensively, and provides very good compression balanced with performance. It also implements an early abort feature[1], meaning it stops trying to compress if initial compression results do not meet a threshold, so performance with incompressible data isn't degraded.
Check Compression Ratio
To check compression performance, the compression ratio can be queried on the Lustre server:
zfs get compressratio <OST_dataset>
From a user's perspective, the logical size and on-disk size of a file can be determined by running the following commands from a Lustre client:
# Check logical usage du --apparent-size -h <file> # Check on-disk usage du -h <file>